Kemppi FastMig MS 200 Operating Manual page 12

NOTE!
value, and therefore the adjustment ranges for the initial and final values are restricted
automatically, if necessary.
Welding Level
Parameters related to these functions are set via the SETUP function (see 'SETUP functions').
Stopping is performed as with the normal 4T function.
The values of parameters related to additional MIG functions can be changed with the SETUP
function (see 'SETUP').
Parameters are selected for adjustment via potentiometer on the left. The value of the
EN
parameter is set via potentiometer on the right. The value is immediately recorded in the
memory.
Activation through SETUP
Other additional MIG functions are activated through SETUP.
• Creep Start is meant to facilitate the initial weld – e.g., when welding with a high wire
feed speed. The wire feed speed is kept low until the wire touches the work piece and
the current begins to flow. Creep Start can be selected with normal MIG welding or with
Synergic 1-MIG welding.
• WiseFusion™ is a welding function for ensuring consistent weld quality in all positions.
It is an optional feature, which can be purchased through Kemppi DataStore.
• WisePenetration™ is a welding function for delivering constant welding power
regardless of changes in the stick out length. It is an optional feature, which can be
purchased through Kemppi DataStore.
• MatchLog™ contains MiniLog™ function for quickly changing welding parameters on
the run. It is an optional feature, which can be purchased through Kemppi DataStore.
• If your welding needs change and you wish to update your system in the future, you can
order additional welding programs or other welding software and load them to your
system with Kemppi DataGun field programming device.
For further information about the available welding programs, modified processes and special
enhanced arc performance solutions, visit Kemppi web site at www.kemppi.com or contact
the local Kemppi dealer.
10
FastMig MS 200, MS 300
In crater fill, the initial value of the welding power must be greater than the final
Crater Fill Start Level
Crater Fill Time
Crater Fill End Level