Table of Contents
Advertisement
SETUP functions (6)
The unit is equipped with a number of additional functions, the selection and parameter value
settings for which are performed via the SETUP function.
The SETUP function is activated by pressing the SETUP button (6) for >1 second. The adjustable
parameter is selected via the left-hand potentiometer (2), the name of which is shown on display
No. 4. The value of the parameter in question is adjusted via the right-hand potentiometer (3), and
the value is shown on the display (5). The parameters and their possible values are:
Name of parameter Name on
display
Creep Start
Cre
Post Current
PoC
Selection of Wire
add
Feeder Address
Maximum Wire
fs
Feed Speed
Disable PMT MIG
gun
guns
Restore Factory
faC
Settings
The parameter's value is immediately recorded in the memory. Exit SETUP mode by holding down
the new SETUP button or by briefly pressing the ON/OFF button.
3.2. KWF 200 ANd KWF 300 OPERATIONS
1
4
2
6
19
Main switch, ON/OFF (1)
The wire feed unit remains in the OFF position when the power source is switched ON, thus
preventing start-up.
OFF is shown on the display.
When the ON/OFF button is pressed for more than 1 second, the unit starts up and all LEDs light
up for a split second.
The unit is now ready for welding and will automatically return to previous position.
The unit starts up also by pressing three times shortly the start switch of the gun.
16 – WeldForce KWF 00, 300, 00S, 300S / 061
Parameter
values
10 ... 170 %
-9 ... +9
85 or 90
8 or 25 m/min 18 m/min the max. wire feed speed
off or on
off or on
7
11 12
8
13
14
15
16
17
Factory
Description
setting
50 %
Percentage of wire feed speed:
10 % slowed start,
170 % accelerated start
0
Post current
85
bus address of wire feeder
selected; dependent on feed
wheels
on
off = other gun
on = Pmt gun
off
restores factory settings when
'on' is selected.
9
18
5
3
10
© Kemppi oy
Advertisement
Table of Contents
