Kemppi FastMig MS 200 Operating Manual page 18

Common Setup -parameters for MIG processes
Name of parameter
Device Address
Using features of PMT
Gun
Gas Guard Connected
LongSystem Mode
Code Entry
EN
PIN Code Entry
Panel Locking
Water Cooler
Wire Inch Stop
Auto Wire Inch
Demo Licence Time
Restore Factory
Settings
16
FastMig MS 200, MS 300
Name on Parameter
display values
Add 3 or 6
Gun OFF, on
GG no, YES
LSY OFF, on
Cod ---, Ent
PIn ---, PIn
LoC OFF, on
Coo OFF, on
Inc OFF, on
AIn OFF, on
dEt 3-h, 2-h, **' ,
**'' , OFF
FAC OFF, PAn, ALL
Factory
Description
setting
3 Wire feeder bus address
on on = PMT gun
OFF = other gun
no Implementation of gas guard
OFF on: Gives optimum welding characteristics
with long welding cables. Recommended
to be used when the cable length exceeds
40 m.
--- Entering license codes manually:
1. Adjust right potentiometer to ('Ent').
2. Press REMOTE.
3. Set code with right potentiometer.
4. Choose next with left potentiometer.
5. Go back to point 3, until all codes have
been set.
6. Approve by pressing REMOTE. ('Suc cEs')
--- Enters pin code for Panel Locking
OFF Enables panel locking
on Enables water cooler
on OFF = Stops wire inch in case arc does not
ignite
on = Feeds wire as long as the welding
gun start switch is pressed.
on SuperSnake Automatic Wire Inch
function. Wire Inch button runs the filler
wire from the wire feeder up to the
SuperSnake.
The remaining time for the WiseDemo
licence
(readable value only).
3-h = max. 3 hours left
2-h = max. 2 hours left
**' = ** minutes left
**'' = ** seconds left
OFF = Demo period has expired.
OFF Control panel reset function.
OFF = No reset
PAn = Settings will be restored, but
memory channels remain unchanged
ALL = All settings will be restored to
factory values.