Alarm Server; Smart Tracking - Speco O4P30X2 User Manual

4mp ptz network camera

Table of Contents

camera switches to day mode or night mode.

Timing: Select the alarm type. Then click "Add" and drag the mouse on the timeline to set the schedule of alarm out; click "Erase"

and drag the mouse on the timeline to erase the set time schedule. After this schedule is saved, the alarm out will be triggered in the

specified time.

5.4.5 Alarm Server

Go to Alarm→Alarm Server interface as shown below.

Set the server address, port, heartbeat and heartbeat interval. When an alarm occurs, the camera will transfer the alarm event to the

alarm server. If an alarm server is not needed, there is no need to configure this section.

(Only some models support this function)

The tracking option is available for line crossing detection, region entrance and exiting and intrusion detection.

Smart Tracking: When people or vehicle cross the alarm line or intrude or exit the predefined area, the PTZ camera will automatically

track them and the target image will be automatically zoomed in and centered on the screen until the target disappears on the screen.

After that, the PTZ camera will return to the tracking start position.

Tracking Mode: PTZ Auto Tracking Priority or Manual PTZ Control Priority can be optional.

PTZ Tracking Priority: if this mode is selected, in smart tracking mode, you cannot control PTZ by clicking the buttons on the PTZ

Table of Contents