4.3.2 Other Alarms
SD Card Full
1. Go to AlarmAnomalySD Card Full.
2. Click "Enable" and set the alarm holding time.
3. Set alarm trigger options. The setup steps are the same as motion detection. Please refer to motion detection chapter for details.
SD Card Error
When there are some errors in writing SD card, the corresponding alarms will be triggered.
1. Go to AlarmAnomalySD Card Error as shown below.
2. Click "Enable" and set the alarm holding time.
3. Set alarm trigger options. Trigger alarm out, Email and FTP. The setup steps are the same as motion detection. Please refer to
motion
detectionchapter for details.
4.3.3 Alarm Server
Go to AlarmAlarm Server interface as shown below.
Set the server address, port, heartbeat, and heartbeat interval. When an alarm occurs, the camera will transfer the alarm event to
the alarm server. If an alarm server is not needed, there is no need to configure this section.
16