Region Entrance; Region Exiting - Speco O4P30X2 User Manual

4. Keep the mounting angle of the camera at about 45°.
5. The detected objects should not be less than 1% of the entire image and the largest sizes of the detected objects should not be
more than 1/8 of the entire image.
6. Make sure cameras can view objects for at least 2 seconds in the detected area for accurate detection.
7. Adequate light and clear scenery are crucial to intrusion detection.

5.5.4 Region Entrance

Region Entrance: Alarms will be triggered if the target enters the pre-defined areas.
Go to Config→Event→Region Entrance interface as shown below.
1. Enable region entrance detection, select the snapshot type and the detection target and set the alarm holding time and alarm
trigger options. The detection setup steps are the same as line crossing detection. Please refer to the detection configuration of line
crossing detection for details.
2. Set the area of region entrance detection. The area setup steps are the same as intrusion detection. Please refer to the area
configuration of intrusion detection for details.
3. Set the schedule of the region entrance detection. The setup steps of the schedule are the same as schedule recording setup (See
Schedule Recording).

5.5.5 Region Exiting

Region Exiting: Alarms will be triggered if the target exits from the pre-defined areas.
Go to Config→Event→Region Exiting interface as shown below.
34