Alarm Server - Speco O4BDD2M User Manual

Alarm Out Mode: Alarm linkage, manual operation, day/night switch linkage and schedule are optional.
Alarm Linkage: Having selected this mode, select alarm out name, alarm holding time at the "Alarm Holding Time" pull down list box
and alarm type.
Manual Operation: Having selected this mode, select alarm type and click "Open" to trigger the alarm out immediately; click "Close"
to stop alarm.
Day/Night Switch Linkage: Having selected this mode, select the alarm type and choose to open or close alarm out when the
camera switches to day mode or night mode.
Timing: Select the alarm type. Then click "Add" and drag the mouse on the timeline to set the schedule of alarm out; click "Erase"
and drag the mouse on the timeline to erase the set time schedule. After this schedule is saved, the alarm out will be triggered in the
specified time.

4.3.5 Alarm Server

Go to AlarmAlarm Server interface as shown below.
Set the server address, port, heartbeat, and heartbeat interval. When an alarm occurs, the camera will transfer the alarm event to
the alarm server. If an alarm server is not needed, there is no need to configure this section.
20