Alarm Server; Analytics Configuration; Abnormality - Speco O4D6 User Manual

Day/Night Switch Linkage: Having selected this mode, select the alarm type and choose to open or close alarm out when the
camera switches to day mode or night mode.
Timing: Select the alarm type. Then click "Add" and drag the mouse on the timeline to set the schedule of alarm out; click "Erase"
and drag the mouse on the timeline to erase the set time schedule. After this schedule is saved, the alarm out will be triggered in the
specified time.

4.3.5 Alarm Server

Go to AlarmAlarm Server interface as shown below.
Set the server address, port, heartbeat and heartbeat interval. When an alarm occurs, the camera will transfer the alarm event to
the alarm server. If an alarm server is not needed, there is no need to configure this section.

4.4 Analytics Configuration

This series of IP cameras supports certain smart functions, such as line crossing detection, region intrusion detection, etc. These
events can be triggered as alarm events.
For more accuracy, here are some recommendations for installation.
Cameras should be installed on stable surfaces, as vibrations can affect the accuracy of detection.

Avoid pointing the camera at the reflective surfaces (like shiny floors, mirrors, glass, lake surfaces and so on).

Avoid places that are narrow or have too much shadowing.

Avoid scenario where the object's color is similar to the background color.

At any time of day or night, please make sure the image of the camera is clear and with adequate and even light,

avoiding overexposure or too much darkness on both sides.
Ensure that the specific analytic enabled meet the minimum requirements for percentage of screen and/or distance.


4.4.1 Abnormality

This function can detect changes in the surveillance environment affected by the external factors.
Go to AnalyticsAbnormality interface as shown below.
19