Alarm Server; Analytics Configuration - Speco O4DM User Manual

4mp ip camera

Table of Contents

Day/Night Switch Linkage: Having selected this mode, select the alarm type and choose to open or close alarm out when the

camera switches to day mode or night mode.

Timing: Select the alarm type. Then click "Add" and drag the mouse on the timeline to set the schedule of alarm out; click "Erase"

and drag the mouse on the timeline to erase the set time schedule. After this schedule is saved, the alarm out will be triggered in the

specified time.

6.1.5 Alarm Server

Go to AlarmAlarm Server interface as shown below.

Set the server address, port, heartbeat, and heartbeat interval. When an alarm occurs, the camera will transfer the alarm event to

the alarm server. If an alarm server is not needed, there is no need to configure this section.

This series of IP cameras supports certain smart functions, such as line crossing detection, region intrusion detection, etc. These

events can be triggered as alarm events.

For more accuracy, here are some recommendations for installation.

Cameras should be installed on stable surfaces, as vibrations can affect the accuracy of detection.



Avoid pointing the camera at the reflective surfaces (like shiny floors, mirrors, glass, lake surfaces and so on).



Table of Contents

O4bm