Alarm Server; Analytics Configuration; Abandoned/Missing Object Detection - Speco O4LB1M User Manual

2. Click "Enable" and set the alarm holding time.
3. Set alarm trigger options. Trigger alarm out, Email and FTP. The setup steps are the same as motion detection. Please refer to
motion detectionchapter for details.

4.3.3 Alarm Server

Go to AlarmAlarm Server interface as shown below.
Set the server address, port, heartbeat, and heartbeat interval. When an alarm occurs, the camera will transfer the alarm event to
the alarm server. If an alarm server is not needed, there is no need to configure this section.

4.4 Analytics Configuration

This series of IP cameras supports certain smart functions, such as line crossing detection, region intrusion detection, etc. These
events can be triggered as alarm events.
For more accuracy, here are some recommendations for installation.
Cameras should be installed on stable surfaces, as vibrations can affect the accuracy of detection.

Avoid pointing the camera at the reflective surfaces (like shiny floors, mirrors, glass, lake surfaces and so on).

Avoid places that are narrow or have too much shadowing.

Avoid scenario where the object's color is similar to the background color.

At any time of day or night, please make sure the image of the camera is clear and with adequate and even light, avoiding

overexposure or too much darkness on both sides.

4.4.1 Abandoned/Missing Object Detection

Alarms will be triggered when the objects are removed from or left at the pre-defined area.
To set object removal detection:
Go to ConfigEventObject Abandoned/Missing interface as shown below.
17