Table of Contents
Advertisement
2. Enable target counting and select the snapshot type and the detection target.
Detection Target: Select the target to calculate. Human, motor vehicle and motorcycle/bicycle can be selected.
Counting Reset: The current number of the target counting can be reset. You can choose to reset the counting daily, weekly or monthly.
Click "Reset" to manually reset the current number of crossing line people/car/bike counting.
3. Set the area of the target counting. Click the "Area" tab to go to the interface as shown below.
Set the alarm line number and direction. Only one alarm line can be added.
Direction：A->B and A<-B can be optional. The direction of the arrow is entrance.
Click the "Draw Area" button and then drag the mouse to draw a line in the image. Click the "Stop Draw" button to stop drawing.
Click the "Clear" button to delete the lines.
Statistics: If enabled, you can see the statistical information in the live view interface. If disabled, the statistical information will not
be displayed in the live view interface.
Check "Statistics" and then move the red box to change the position of the statistical information displayed on the screen. Click the
"Save" button to save the settings.
4. Set the schedule of the target counting. The setup steps of the schedule are the same as schedule recording setup (See
Schedule
Recording).
5. View the statistical information in the live view interface.
36
Advertisement
Table of Contents
