Control Panel - Loma X5c Operating Instructions Manual

24

Control Panel

INTERLOCK
KEY
CONVEYOR This button is used to start and stop the conveyor as follows:
EMERGENCY
STOP
Document Number: 814212-2.0-ENG
The Interlock Key is used to prevent accidental generation of X-Rays.
It has three positions as follows:
 ON - When the key is in this position X-Rays can be generated.
 OFF - When the key is in this position X-Rays cannot be
generated.
 Green - When the button is green this indicates that the
conveyor is running. Press the button to stop the conveyor.
 Red - When the button is red, this indicates that the conveyor
is not running. Press the button to start the conveyor.
In an emergency, pushing in this button will immediately stop the
generation of X-Rays and the conveyor.
Following clearance of any fault, the button is reset by twisting it a
quarter turn in a clockwise direction and then releasing it.
An additional emergency stop button is provided on the rear panel
of the machine.
Getting Started
Original Document