GBC DIGITAL FEEDER Operation & Maintenance Manual page 56

Installation
INFORMATION
The encoder on the Explorer 107
synchronizes the speed of the feeder.
e) Press under VACUUM on the feeder.
ON
f) Press under RUN on the feeder.
ON
g) Push in the E-STOP located below the feeders
ON/OFF.
- Power to the feeder control panel is
removed.
Page 4 - 22
Digital Feeder Operation and Maintenance Manual
VACUUM
O N O F F
RUN
O N O F F
P u s h
in
d) Rotate the E-STOP clockwise to reset.
Rotate
- Power to the feeder control panel is restored.
INFORMATION
The Explorer 107 E-STOPS will stop
the feeder. Once the upper pull roller
is engaged and turning, the feeder
will resume running.
INFORMATION
The feeder will only operate if the
Explorer 107 is running and the sheet
stack limit switch is engaged.
© GBC Pro - Tech February 2000