GBC DIGITAL FEEDER Operation & Maintenance Manual page 50

Installation
You, the customer, have two options to connecting
air to the feeder. (1) connect air directly to the filter or (2)
connect air to the filter via a quick disconnect coupler*.
* If using 1/4 inch O.D. pneumatic tubing, you
may use a Quick Change coupler ( GBC P/N 330260 )
and a male air fitting connector ( GBC P/N 330600 ).
a) Connect air to the air filter mounted on the
feeder near the electrical box.
Connect air here
INFORMATION
The JUN-AIR compressor will not work for
the feeder due to lack of air volume.
Page 4 - 16
Air
Digital Feeder Operation and Maintenance Manual
The encoder cable allows the laminator and the
feeder to communicate as one unit. The laminator will
determine the speed of the feeder.
a) Remove the encoder cable from the accessory
bag.
Both ends of the encoder cable are identical.
b) Connect one end of the encoder cable to the
electrical box encoder receptacle.
Encoder
receptacle
© GBC Pro - Tech February 2000
Encoder
INFORMATION