GBC DIGITAL FEEDER Operation & Maintenance Manual page 55

Digital Feeder Operation and Maintenance Manual
Emergency stops
Leave the sheet stack, the feeding head unit and
the sheet table in the current position and continue with
checking the emergency stop checks.
INFORMATION
Ensure no E-STOP is depressed.
INFORMATION
Explorer 107: Ensure no E-STOP is
depressed and the front safety shield is in
the fully closed and locked position.
a) Press POWER to " I " on the Explorer 107.
!
ROLL LAMINATOR
Model : Explorer 107
Input voltage : 220V~ / 60Hz
Input current : 27A
Power cunsuption : 5,800 W
Temperature range: Up to 160
Current rating of circuit breaker : 30 A
Max laminating width : 1075 mm
Serial No : #############
Made in Korea / Fabrique En Coree
© GBC Pro - Tech February 2000
Power
o C
b) Lower the pull roller on the Explorer 107.
INFORMATION
The encoder is attached to the upper pull
roller on the Explorer 107.
c) Rotate SPEED to " 5 " on the Explorer 107
control panel.
MOTOR SPEED
d) Press RUN under AUTO. The rollers begin
turning.
MOTOR SPEED
Installation
REVERSE
O N O F F
REVERSE
O N O F F
Page 4 - 21