GBC DIGITAL FEEDER Operation & Maintenance Manual page 19

Digital Feeder Operation and Maintenance Manual
INFORMATION
Ensure no E-STOP is depressed.
Keep hands and feet away from the sheet
table when raising or lowering.
You may be crushed!
INFORMATION
Explorer 107: Ensure no E-STOP is
depressed and the front safety shield is in
the fully closed and locked position.
INFORMATION
The encoder is attached to the upper pull
roller on the Explorer 107.
INFORMATION
The encoder on the Explorer 107 sets the
speed of the feeder to match.
© GBC Pro - Tech February 2000
WARNING
INFORMATION
The Explorer 107 E-STOPS will stop
the feeder. Once the upper pull roller
is engaged and turning, the feeder
will resume running.
INFORMATION
The feeder will only operate if the
Explorer 107 is running and the sheet
stack limit switch is engaged.
INFORMATION
Refer to Section 5.3 Job programming
to store parameters.
Safety
Page 1 - 7