Installation - GBC DIGITAL FEEDER Operation & Maintenance Manual

Digital Feeder Operation and Maintenance Manual
To continue operation, the E-STOP must be in
the unlatched position. To reset the E-STOP, twist 1/4
turn clockwise.
Rotate
INFORMATION
The E-STOP on the Explorer 107 will
stop the feeder. The E-STOP on the
feeder will not stop the Explorer 107.
INFORMATION
The feeder will only operate if the
Explorer 107 is running and the sheet
stack limit switch is engaged.
© GBC Pro - Tech February 2000

1.3 Installation

The following symbols are positioned at various
points in Section 4 Installation.
Failure to follow the pre-installation check
list can result in damage to the cutter.
The Digital Feeder is a large and heavy
piece of equipment. It is necessary to
e m p l o y L I C E N S E D R I G G E R S O N L Y t o
move the machine. The machine is not
designed to be tipped up or sideways in any
way. Such action disturbs the exact
alignment of the moving parts of the
machine and requires extensive realignment.
You can be crushed or seriously injured.
INFORMATION
If you have a GBC Digital Cutter inline with
the feeder and laminator, refer to Figure
4.1.2 Optional cutter layout
Safety
CAUTION
WARNING
Page 1 - 3