GBC DIGITAL FEEDER Operation & Maintenance Manual page 14

Safety
INFORMATION
Only a qualified service technician should
perform any procedure requiring the
cabinet covers to be removed.
The word qualified is defined below;
Qualified ;
• Any engineer that has experience with electrical
and mechanical design of lamination equipment.The
engineers should be fully aware of all aspects of safety
with regards to lamination equipment.
• Any commissioning or service engineer must be
of competent nature, trained and qualified to GBC Pro-
Tech standards to fulfill that job. This person will have
completed and passed the full service training course from
GBC Pro-Tech.
• Any GBC Technician, GBC Specialist, and / or
GBC Pro-Tech Technician that has been through the GBC
Pro-Tech service training course.
An important feature of the Digital Feeder is the
emergency stop and limit switches. Refer to Figure 1.2.1
Page 1 - 2
Digital Feeder Operation and Maintenance Manual
At no time should you attempt to override
any of the safety devices on the machine.
Figure 1.2.1 Safety devices
Emergency stop
To engage the EMERGENCY STOP feature,
push in. This will remove power to the feeder motors.
© GBC Pro - Tech February 2000
DANGER
Table limit
switches
P u s h
in