GBC DIGITAL FEEDER Operation & Maintenance Manual page 46

Installation
Installing the conveyor
a) Use the # 2 Phillips screw driver to remove the
two screws securing the conveyor drive
sprocket cover.
Conveyor drive sprocket cover
b) Use a second person to assist with lifting the
conveyor and setting the rear of the conveyor to
the front of the feeder..
Page 4 - 12
Digital Feeder Operation and Maintenance Manual
c) The third person will push the feeder forward
while the two people supporting the conveyor
align it to the two support bars on the laminator.
d) Replace the conveyor drive sprocket cover
and secure with the two screws using the # 2
Phillips screw driver.
e) Insert the safety key attached to the conveyor
into the interlock switch on laminator.
© GBC Pro - Tech February 2000
Support
bars
Safety key