GBC DIGITAL FEEDER Operation & Maintenance Manual page 48

Installation
d) Position the level on the rear cross bar. Refer to
Figure 4.7.3 Rear cross bar.
e) With two 19 mm wrenches, adjust the foot bolts
so that the front side is even from left to right.
Refer to Figure 4.7.2 Foot bolt
Front side to back side
a) Position the level on the control side. Refer
to Figure 4.7.4 Control side
Figure 4.7.4 Control side
Level
Page 4 - 14
Level
Digital Feeder Operation and Maintenance Manual
b) With two 19 mm wrenches, adjust the foot bolts
so that the control side is even from front to
back. Refer to Figure 4.7.2 Foot bolt
c) Position the level on the drive side. Refer
to Figure 4.7.5 Drive side
Figure 4.7.5 Drive side
d) With two 19 mm wrenches, adjust the foot bolts
so that the drive side is even from front to back.
Refer to Figure 4.7.2 Foot bolt
e) Verify all four leveling points to ensure that all
four sides are leveled.
© GBC Pro - Tech February 2000
Level