Planing Of Small Workpieces; Planing Of With Tiltied Planer Fence; Planing Of Short Workpieces - HOLZMANN MASCHINEN HOB260ABS Operating Manual

16.7.1 Planing of small workpieces

16.7.2 Planing of with tiltied planer fence

16.7.3 Planing of short workpieces

HOLZMANN MASCHINEN GmbH
 Fix the planer fence (1) in the desired working
 Set the desired cutting depth on the adjusting
 Adjust the blade guard (3) so that the distance
 Start the machine on by pressing the ON-button.
 Press the workpiece against the entry planer table
 With the second hand (5), push the workpiece
 After finisching the operation, switch off the
 Wait until the shaft has come to a standstill before
www.holzmann-maschinen.at
position.
screw (2).
between the cover and the workpiece is approx.
5mm.
with one hand (4).
slowly and evenly over the shaft.
machine by pressing the OFF-button.
carrying out any further work!
 Lower the blade guard (3) so that the shaft is
covered.
 Move the blade guard to the workpiece and fix it
with a distance of approx. 5mm.
 When planing, place the workpiece with the
small side on the planer table and press with one
hand against the planer fence and planer table.
 Push the workpiece slowly and evenly over the
shaft with the second hand.
 Loosen the fixing lever of the planer fence (1).
 Place the workpiece against the planer fence.
 Adjust angle, fix planer fence.
 Lower the blade guard (3) so that the shaft is
covered.
 Adjust blade guard, 5mm distance to workpiece.
 Switch on the machine.
 When planing, place the workpiece with the
small side on the planer table and press with one
hand against the planer fence and planer table.
 Push the workpiece slowly and evenly over the
shaft with the second hand.
 When planing, workpieces with a small cross-
section, an additional wood angle must be fitted!
 Adjust planer fence and blade guard to the size
of the sliding wood.
 Place the workpiece on top and push it slowly
and evenly over the shaft using the sliding wood.
 After use, the sliding wood must be reattached
on his place on the side of the machine.
OPERATION
50
HOB 260ABS