Thicknessing; Surface Planing Of Workpieces With A Small Cross Section; Working Conditions For Thicknessing - HOLZMANN MASCHINEN HOB260ABS Operating Manual

16.7.4 Surface planing of workpieces with a small cross section

16.8 Thicknessing

It is necessary to modify/adjust the machine before using as a thicknesser.
Before carrying out any modification, the machine must be switched off and secured
against being switched on again.

16.8.1 Working conditions for thicknessing

 Long, protruding workpieces must be sufficiently supported! Use suitable aids such as
roller blocks etc. for this purpose. If you do not follow these instructions, there is a danger
of the workpiece being raised up quickly and/or the machine being tilted!
 Use the thicknessing function only to reduce the thickness of a workpiece with an already
surface planed facing!
 For workpieces with a difference in thickness, the chip removal must be measured at the
maximum thickness and the workpiece machined with this side first.
 Make sure that the workpiece to be machined is free of foreign objects and/or knots in
order to avoid dangerous fractures.
 Only plane workpieces that rest firmly on the machine and can be guided safely!
 If several workpieces are to be processed in series, all pieces of the same thickness should
be run through in succession without changing the setting.
 Perform the machining process from the beginning until the desired thickness is achieved.
HOLZMANN MASCHINEN GmbH
NOTICE
WARNING
www.holzmann-maschinen.at
 When planing workpieces with a small cross-
section, an additional wood angle must be
mounted!
 Fasten the wood angle to the planer fence as
shown using lever clamps.
 When planing, place the workpiece on the planer
table and press it against the additional wood
angle and planer table.
 Place the workpiece on top and push it slowly
and evenly over the shaft using the sliding wood.
OPERATION
51
HOB 260ABS