Balanced Body Studio Reformer Manual page 12

PARTS LIST
DESCRIPTION
Studio Reformer
Red Springs
Blue Spring
Green Spring
Cotton Loops (pair)
Neoprene Handles (pair)
Ropes (pair)
Carriage Extension Stopper
Sitting Box
Wooden Risers (pair)
Riser Bolts
Pully Assembly (pair)
Shoulder Rest Kit TwistLock
TwistLock Post
with Classic Footbar
Short Foot Strap
Spring Bar
with Revo Footbar
Revo Foot Strap
with Infinity Footbar
Revo Foot Strap
Complete Infinity footbar with
Trunnions Attached
Footbar Stoppers
Footbar Stopper Screws
Plunger Knob Wrench
INSTALL THE CARRIAGE
1. Turn the carriage over and clean both the wheels and the full
length of the rail surfaces inside the frame. Carefully place the
carriage into the frame with the headrest facing away from
the footbar.
ATTACH THE SPRINGS TO THE UNDERSIDE OF
THE CARRIAGE
2. Locate the bracket with
five eye-bolts attached
beneath the carriage. Hook
the springs onto the
eyebolts. The hook
opening should be facing
down.
. The bodies of the springs should rest on the flat, padded
brace under the carriage (Fig A).
10
PART NO QTY
SPR9070 3
SPR7071 1
SPR9293 1
101-005 1
101-016 1
210-026 1
200-211 1
721-002 1
950-034 1
GEN7314 4
GEN9039 1
950-251 1
616-400 2
101-011 1
950-053 1
210-030 1
210-030 1
N/A 1
REF0702 2
GEN9027 2
ALL0060 1
Fig A
INSTALL THE STANDARD WOODEN RISERS
3. The adjustable riser blocks
come with four screws
and a hex key provided
in a hardware package.
Install the riser blocks to
the outside of the frame
at the head end. The long
slots in the risers go to the
top with the fully rounded
edges facing out as shown
in Figure B. Start threading
both screws by hand in one
riser block before tightening.
. When both screws are
engaged, tighten them with the hex key.
Repeat with the other riser.
ATTACH THE PULLEYS TO THE WOODEN RISERS
4. The hardware package
contains two pulleys with
black knobs. Unscrew the
black knobs and remove.
Take off one of the large
washers from the exposed
bolt on a pulley and install
the bolt through the slot on
a riser.
. Place the washer back onto
the bolt on the backside of
the riser and add the black knob.
. Do this to both risers, making sure the pulleys are facing the
carriage. See Figure C for proper orientation.
. Raise and lower the pulleys by loosening the black knob and
sliding the pulley up or down in the slot, then tighten the black
knob. Be careful to not over tighten the knob.
ATTACH THE ROPES
5. To attach the ropes, first engage at least one carriage spring
to the springbar to hold the carriage in place. Unroll and
separate the ropes.
Fig B
Fig C