Advertisement
Quick Links
IMPORTANT!
PLEASE READ BEFORE INSTALLING THE LIBRARY WHEELS ON YOUR BALANCED BODY
PILATES IQ™ REFORMER
THESE INSTRUCTIONS WILL REPLACE THE CURRENT "LIBRARY WHEELS" INSTALLATION
INSTRUCTIONS ON PAGE 2.
To Install:
Orient the wheel brackets so that the footstrap hole is outside of the machine.
§
Using the 5/32" Allen key, remove the two screws corresponding to the smaller bracket holes.
§
Install the bracket, replace the screws and tighten.
§
Repeat on the other side.
§
Please follow all assembly instructions carefully, including the IQ Knob addendum on the other side of this sheet.
Questions? Call 1-800-PILATES x219 for tech support.
§
8220 Ferguson Avenue
Sacramento, CA 95828
§
§
916-388-2838
916-379-9277 FAX
Advertisement
Related Manuals for Balanced Body IQ REFORMER
Summary of Contents for Balanced Body IQ REFORMER
- Page 1 IMPORTANT! PLEASE READ BEFORE INSTALLING THE LIBRARY WHEELS ON YOUR BALANCED BODY PILATES IQ™ REFORMER THESE INSTRUCTIONS WILL REPLACE THE CURRENT “LIBRARY WHEELS” INSTALLATION INSTRUCTIONS ON PAGE 2. To Install: Orient the wheel brackets so that the footstrap hole is outside of the machine.
-
Page 2: Parts List
1-800-Pilates (1-800-745-2837). notice One (1) Assembled IQ Reformer frame and carriage, with five (5) springs pre-attached Photos: The photos in this document show the IQ with wheelbarrow wheels in One (1) Frame handle (219-050) some and library wheels in others. -
Page 3: Installing The Wheels
installing tHe wHeels installing and adjusting tHe footbar Two types of wheels can be ordered with the IQ – “wheelbarrow” wheels or “library” wheels (see photos). To install either wheel set make sure the IQ is The IQ footbar can be adjusted to four on the ground and right side up. - Page 4 extending tHe frame tHreading tHe roPes Be sure the springs are attached so the carriage is secure. Place the loops over The IQ frame has three positions: the shoulder rests. The D-ring attached to the loops should point toward the one shortened for storage, and two pulleys.
- Page 5 To attach the footstrap when using a sitting box, just connect it to the footstrap holes on both sides of the bottom–end of the frame (see photo). if you have any questions about these instructions, call balanced body customer service at 1-800-Pilates (1-800-745-2837) 09/06...
- Page 6 How to Install Your Balanced BodY PIlates IQ™ reformer KnoBs to Protect Parts from damage durIng sHIPPIng, Your IQ reformer comes wItH tHe frame KnoBs detacHed. Please use tHe followIng InstructIons to reattacH. Black Washer Parts you will need: Fig. 1 602-011 6/32 by 3/8” Allen cap screw (2)