Summary of Contents for Balanced Body Reformer Trapeze Combination
Page 1
How to Assemble The Balanced Body® Reformer Trapeze Combination™ REFORMER PARTS LIST CANOPY/TRAPEZE PARTS LIST Description Part Number Qty. Description Part Number Qty. Cotton Footstrap 210-030 Ankle Velcro (pair) 101-001 Red Reformer Spring SPR9070 Long Cotton Web, Black (pair) 101-026...
Page 2
Corner Connector Canopy Top Top Slider Cotton Slider Webs with Fuzzies a Push Through Bar (PTB) Leg Springs b a Quick Relase T-Pin Roll Down Bar Safety Strap Vertical Tubes b Belly Strap (not shown) Mat Conversion (not shown) Flange Connectors...
Page 3
Shoulder Rests h Footbar b Risers Reformer Mode ASSEMBLE THE TRAPEZE CANOPY ASSEMBLE THE REFORMER 1. Using the provided 3/16” allen wrench, loosen the set screws 5. Swing the footbar up and place the support into position. in each of the eight flanges mounted to the outside of the 6.
Page 4
7. Place the remaining mat on the foot-end of the Reformer. Make sure the end of the mat with the feet further from the Call Balanced Body Technical Support at 1-800-PILATES or edge is installed over the standing platform. +1-916-388-2838.