Connecting The Power - Bosch VEZ-221-ECCE Installation Manual

64 en | Preparing the Wiring
8.2

Connecting the Power

The AutoDome Easy II IP is available as an indoor or as an
outdoor model. Power to the camera in all indoor models is
supplied via a single power connector or via a Power over
Ethernet (PoE, IEEE 802.3af) connection using the existing CAT
5E Ethernet cable.
The outdoor models contain two 24 VAC isolated power
connectors, one for the camera (red and black wires) and one
for the heater (white/red and white/black wires).
NOTICE!
Use certified / Listed Class 2 power supply transformer only.
Determining Power Connections
The table below summarizes the necessary power connections
for indoor and outdoor IP models. Use the table to identify the
necessary connections and for direction to the proper section.
Model
IP
Indoor
Outdoor 24 VAC
F.01U.164.576 | 2.0 | 2010.03
Connection
24 VAC
PoE to camera
24 VAC to heater
Installation Manual
Refer to
Section 8.2.1 Power Connections to Indoor
Cameras, page 65
Section 8.3 Ethernet Connection (IP
models), page 67
Section 8.2.2 Power Connections to Outdoor
Cameras, page 66
Section 8.2.3 Power Connections to Heater
(all outdoor models), page 67
Bosch Security Systems, Inc.
AutoDome Easy II IP