Bosch VEZ-221-ECCE Installation Manual page 51

AutoDome Easy II IP
12.
NOTICE!
The recessed mounting bracket is provided with a an additional
safety tether point. To prevent injury, attach a safety wire from
a secure anchor point above the ceiling to this tether point.
13. Align trim ring so screws align with off center holes.
14. Use supplied T-10 wrench to secure the trim ring's two (2)
15. Snap trim ring into place. Ensure snaps are secure by
Bosch Security Systems, Inc.
Ensure unit is centered.
Figure 6.9 Align Trim Ring
1 Clamp
2 Stand-offs
3 Trim Ring
Note: The two (2) sets of raised stand-offs on each side of
the trim ring align with the locking clamps.
safety locking screws to the mounting bracket.
attempting to lightly turn unit. Note: Unit should not turn.
Installation Manual
Installing a Recessed Mount | en
F.01U.164.576 | 2.0 | 2010.03
51