Power Connections To Indoor Cameras - Bosch VEZ-221-ECCE Installation Manual

AutoDome Easy II IP
8.2.1

Power Connections to Indoor Cameras

WARNING!
The indoor IP camera models can accept power from the
24 VAC power input or from the Ethernet input. Ensure that the
camera receives power from only one source.
Refer to Section 8.3 Ethernet Connection (IP models), page 67,
for more information about connecting Power over Ethernet.
Figure 8.1 Power Cable
Ref. # Wire
1
2
3
NOTICE!
The camera unit accepts 24 VAC 1.2 A power only. Do not
connect 120 V or 230 V to this camera.
To connect the power to indoor models:
1.
2.
3.
4.
Bosch Security Systems, Inc.
24 VAC
24 VAC
User supplied Power Supply
Locate the cable assembly with a three (3) pin mating
connector on one end and the red and black flying leads on
the other end.
Connect one lead of the 24 VAC power source to the black
wire.
Connect the other lead of the 24 VAC power source to the
red wire.
Connect the green earth ground cable to a suitable
grounded conduit.
Installation Manual
Preparing the Wiring | en
Color
Red
Black
n/a
F.01U.164.576 | 2.0 | 2010.03
65