Autodome Easy Ii Ip Operation And Control - Bosch VEZ-221-ECCE Installation Manual

AutoDome Easy II IP
17.1 AutoDome Easy II IP Operation and
Control
Malfunction
No connection
between the unit
and terminal
program.
No image
transmission to
remote station.
Bosch Security Systems, Inc.
Possible causes
Incorrect cable
connections.
The computer's serial
interface is not
connected.
Interface parameters
do not match.
Camera error.
Faulty cable
connections.
Incorrect encoder
stream property set for
connection to
hardware decoder.
Installation Manual
Troubleshooting | en 129
Recommended solution
Check all cables, plugs,
contacts, terminals and
connections.
Check the other serial
interface.
If necessary select a different
interface and make sure that
the computer's interface
parameters match those of
the unit. Try the following
standard parameters: 19,200
baud, 8 data bits, no parity,
1 stop bit. Next, disconnect
the unit from the power
supply and reconnect it again
after a few seconds.
Connect local monitor to the
camera and check the camera
function.
Check all cables, plugs,
contacts and connections.
Select the H.264 BP+ (HW
decoder) option on the
Encoder Streams
configuration page.
F.01U.164.576 | 2.0 | 2010.03