Basic Mode: Network - Bosch VEZ-221-ECCE Installation Manual

AutoDome Easy II IP
Time server IP address
The AutoDome Easy II IP can receive the time signal from a time
server using various time server protocols, and then use it to
set the internal clock. The unit polls the time signal
automatically once every minute.

Time server type
Select the protocol that is supported by the selected time
server. Preferably, you should select the SNTP server as the
protocol. This supports a high level of accuracy and is required
for special applications and subsequent function extensions.
Select Time server for a time server that works with the
protocol RFC 868.
12.3

Basic Mode: Network

The settings on this page are used to integrate the AutoDome
Easy II IP into an existing network.
Some changes only take effect after the unit is rebooted. In this
case, the Set button changes to Set and Reboot.
1.
2.
CAUTION!
If you change the IP address, subnet mask or gateway address,
the AutoDome Easy II IP is only available under the new
addresses after the reboot.
DHCP
If a DHCP server is employed in the network for the dynamic
assignment of IP addresses, you can activate acceptance of IP
addresses automatically assigned to the AutoDome Easy II IP.
Certain applications (VIDOS, Bosch Video Management System,
Archive Player, Configuration Manager) use the IP address for
the unique assignment of the unit. If you use these applications,
the DHCP server must support the fixed assignment between IP
address and MAC address, and must be appropriately set up so
Bosch Security Systems, Inc.
Enter the IP address of a time server here.
Make the desired changes.
Click the Set and Reboot button. The AutoDome Easy II IP
is rebooted and the changed settings are activated.
Installation Manual
Configuring the AutoDome Easy II IP | en
F.01U.164.576 | 2.0 | 2010.03
89