Specifying Bert Settings - JDS Uniphase HST-3000 User Manual

Chapter 3 ISDN PRA testing
Specifying test settings
Specifying
BERT settings
58
19 If you selected a specific CUG, enter the value of the
closed user group.
This is only available in DASS2 protocol.
You are finished specifying Call settings.
The BERT settings menu varies depending on the application.
For example, if you are running the BERT macro, the settings
are different than the HIZBERT application. The following
procedure describes how to specify the BERT settings.
To specify the BERT settings
1 Press the Configure
The test configuration soft keys appear.
2 Press the BERT soft key. You may need to use the left or
right arrow button to find the BERT soft key.
The BERT Settings menu appears.
3 Select BERT Pattern and then choose a pattern.
The BERT patterns are described in
Patterns, Defects, Anomalies, and
4 Select Error Insertion and then select how frequently
errors are inserted.
This selection is not available in HIZBERT.
HST-3000 E1 Testing User's Guide
navigation key.
Appendix C "BERT
Messages".