Pra Monitor Connections; S 2 /T 2 Monitor - JDS Uniphase HST-3000 User Manual

Chapter 3 ISDN PRA testing
Connecting to the line
PRA Monitor
connections
S T Monitor If you are testing using the S
2/ 2
72
2 Connect the other end of the cable into the PBX.
U
2
PBX
Figure 20 Connecting as a DASS2 ET
The cables are connected.
If you are testing using a PRA Monitor function, the following
paragraphs describe how to connect to the line.
Figure 21 shows how to connect to the line.
To connect to the line
1 With the first cable, connect one end of the test cable to
the RX/TX1 jack on the left side of the module.
HST-3000 E1 Testing User's Guide
RX/TX1
port
/T
2 2
U
2
Network
PBX
Monitor application,