Table of Contents
Advertisement
Advanced System Use & Maintenance
1. Turn OFF the computer and unplug the power cord.
2. Move the jumper cap from pins 1-2 (default) to pins 2-3. Keep the cap on pins 2-3 for about 5-10
seconds, then move the cap back to pins 1-2.
3. Plug the power cord and turn ON the computer.
4. Hold down the <Del> key during the boot process and enter BIOS setup to re-enter data.
Except when clearing the RTC RAM, never remove the cap on CLRTC jumper default position.
Removing the cap will cause system boot failure!
If the steps above do not help, remove the onboard battery and move the jumper again to clear the
CMOS RTC RAM data. After the CMOS clearance, reinstall the battery.
Figure 75- Clear RTC RAM
VGA controller setting (3-pin VGA_SW1)
This jumper allows you to enable or disable the onboard VGA controller. Set to pins 1-2 to activate the
VGA feature.
User Manual
Rev. 1, November 2011
ApplianceStor
50
55
Advertisement
Table of Contents
