Table of Contents
Advertisement
Hardware Installation
Figure 23- HD carrier
4. Place a SATA/SAS hard disk drive on the tray; then secure it with four screws.
Figure 24- HD install in carrier
5. Carefully insert the drive tray and push it all the way to the depth of the bay until just a small
fraction of the tray edge protrudes.
Figure 25- Install carrier and drive
6. Push the tray lever until it clicks, and secures the drive tray in place. The drive tray is correctly
placed when its front edge aligns with the bay edge.
7. Repeat steps 1 to 6 if you wish to install a second SATA/SAS drive.
Expansion slot
Installing an expansion card to the riser card bracket
User Manual
Rev. 1, November 2011
ApplianceStor
50
22
Advertisement
Table of Contents
