Table of Contents
Advertisement
Hardware Installation
Hard disk drives
The system supports four hot-swap SATAII/SAS hard disk drives and two SATAIII hard disk drives*. The hard
disk drive installed on the drive tray connects to the motherboard SATA/SAS ports via the SATA/SAS
backplane.
To install a hot-swap SATA/SAS HDD
1. Release a drive tray by pushing the spring lock to the right, then pulling the tray lever outward.
The drive tray ejects slightly after you pull out the lever.
Figure 21-HD carrier unlatch
2. Firmly hold the tray lever and pull the drive tray out of the bay.
Figure 22- HD carrier open
3. Take note of the drive tray holes. Each side has three holes to fit different types of hard disk drives.
Use two screws on each side to secure the hard disk drive.
User Manual
Rev. 1, November 2011
ApplianceStor
50
21
Advertisement
Table of Contents
