Table of Contents
Advertisement
Hardware Installation
Removing the rear cover
1.
Locate and remove the front side screws.
Figure 14- remove chassis cover
2. Loosen the two thumbscrews on the rear panel to release the rear cover from the chassis.
Figure 15- rear thumb screws
3. Firmly hold the cover and slide it toward the rear panel for about half an inch until it is disengaged
from the chassis.
4. Lift the cover from the chassis.
5. To recover the rear cover, reverse step 1 to 4.
A protection film is pre-attached to the system
cover before shipping. Please remove the
protection film before turning on the system
for proper heat dissipation.
System memory
Overview
The motherboard comes with six (6) Double Data Rate 3 (DDR3) Dual Inline Memory Modules (DIMM)
sockets.
The figure illustrates the location of the DDR3 DIMM sockets:
User Manual
Rev. 1, November 2011
Figure 16- Remove protective tape
ApplianceStor
50
18
Advertisement
Table of Contents
