Table of Contents
Advertisement
Hardware Installation
Select one unit of space (1 U) on the rack where you want to install the barebone server.
3.
Measure the depth of the rack to determine the length of the rack rails.
4.
Adjust the rack rail to ensure that it fits the rack.
5.
Position the rack rail to the 1U space on the rack. Ensure that the front end of the rack rail goes to the
6.
front of the rack space.
Figure 10- Rails and rack installation
Secure the front end of the rail with two rack screws, as shown in the right figure.
7.
Secure the rear end of the rail with two rack screws, as shown in the right figure.
8.
Fasten the eight screw you secure in step 2, as shown in the right figure.
9.
Repeat steps 6 to 9 to assemble and attach the rack rail on the other side.
10.
Mounting the server to the rack
To mount the server to the rack
Place the server on the rack rails, and then push the server all the way to the depth of the rack.
1.
Figure 11- install server in rack
User Manual
Rev. 1, November 2011
ApplianceStor
50
16
Advertisement
Table of Contents
