Table of Contents
Advertisement
Advanced System Use & Maintenance
Figure 97- Auxiliary panel
1.
Front panel SMB (6-1 pin FPSMB) These leads connect the front panel SMBus cable.
2.
LAN activity LED (2-pin LAN1_LED, LAN2_LED) These leads are for Gigabit LAN activity LEDs on
the front panel.
3.
Chassis intrusion (4-1 pin CHASSIS)
These leads are for the intrusion detection feature for chassis with intrusion sensor or microswitch.
When you remove any chassis component, the sensor triggers and sends a high-level signal to these
leads to record a chassis intrusion event. The default setting is short CASEOPEN and GND pin by
jumper cap to disable the function.
4.
Locator LED (2-pin LOCATORLED1 and 2-pin LOCATORLED2) These leads are for the locator
LED1 and LED2 on the front panel. Connect the Locator LED cables to these 2-pin connector. The
LEDs will light up when the Locator button is pressed.
5.
Locator Button/Swich (2-pin LOCATORBTN)
These leads are for the locator button on the front panel. This button queries the state of the system
locator.
User Manual
Rev. 1, November 2011
ApplianceStor
50
68
Advertisement
Table of Contents
