Explanation Of The Values Of The Main Board Settings - GRAPHTEC FC9000-75 Service Manual

8.4

Explanation of the Values of the Main Board Settings

The default factory adjustment values are recorded on label in the location shown below.
When the SUB-NVRAM of adjustment values are not able to copy to the main board, use this values.
If you have changed any values by making adjustments, record those values for the next maintenance check.
Explanation of the values
• PEN FORCE
• DISTANCE
• RMS
• C-CUT
• PENSEL
• 1-2TOOL
• MEDIA SENS
FC9000-UM-251-9370
PEN FORCE
10 48 130
xx xx xxx
RMS C-CUT
X Y
xx.xx xx.xx xx.xx
Pen force adjustment values for each target force.
X and Y for the distance adjustment value, Z for the diagonal distance value
used to the right angle adjustment.
X and Y for the offset adjustment value of the registration mark sensor
position.
Cross cutter position adjustment value.
Pen exchange position adjustment value (This is recorded when the option 2
pen kit was installing.).
1 - 2 Tool spacing adjustment value (This is recorded when the option 2 pen
kit was installing.).
Front and rear media sensor position adjustment values.
210 515 618
xxx xxx xxx
PENSEL 1-2TOOL
Y Y H X
xx.xx xx.xx xx.xx
8-8
8 Electrical Adjustment
DISTANCE
X Y Z
xxx.xx xxx.xx xxx.xx
MEDIA SENS
Y F R
xx.xx xx.xx xx.xx