Adjusting The Cross Cutter Home Position; Inputting The Cross Cutter Home Position From The Recorded Values - GRAPHTEC FC9000-75 Service Manual

8 Electrical Adjustment

8.16 Adjusting the Cross Cutter Home Position

This adjustment will set the cross cutter home position value.
Perform this procedure if adjustment values could not copy from the SUB-NVRAM when replacing the main
board.
When the pen block or the cross cutting mechanism parts was replaced, this adjustment must be performed.
8.16.1 Inputting the Cross Cutter Home Position from the recorded
values
How to input Cross Cutter Home Position from the recorded values
(1) Turn on the power while pressing the SLOW and the ENTER keys.
(2) The plotter displays the following menu.
(3) Press the PAUSE/MENU key to display the following menu.
(4) Press the Right Position key to display the following menu.
(5) Press the Down position key until the following menu is displayed.
(6) Press the F2 key to display the following menu.
FC9000-UM-251-9370 8-40