Table of Contents
Advertisement
(8) Remove the three M4L6 binding head screws attaching the pen block, and then detach the pen block
from the Y slider.
Regarding the spare parts of pen block
The spare parts of pen block is not including the registration mark sensor and the cross cutter blade.
When the pen block is replacing, remove the registration mark sensor and the cross cutter blade from the
used pen block.
How to reinstall the pen block
(1) Attach the pen block to the Y-slider.
(2) Fasten the three M4L6 binding head screws to attach the pen block so that there is a gap of 10 mm
between the bottom of the pen block and the cutting mat. Perform a visual check to make sure that the
pen block is not mounted at an angle.
(3) Reattach the other parts in the reverse order in which they were detached.
(4) Perform the pen force adjustment (Refer to subsection 8.11.2.).
(5) Perform the registration mark sensor sensitivity adjustment (Refer to subsection 8.13.).
(6) Perform the registration mark sensor offset adjustment (Refer to subsection 8.14.2.).
FC9000-UM-251-9370
Pen block
Cutting mat
7
DISASSEMBLY AND REASSEMBLY
M4L6 binding head screw
7-19
10 mm
Advertisement
Table of Contents
