GRAPHTEC FC9000-75 Service Manual page 191

(5) Press the Right Position key to display the adjustment menu shown below.
(6) Press the F1 key to display the menu shown below.
Each short forms are corresponding to the sensors and the control panel switches as shown below.
Short form Sensor or key
YHOME Y home sensor P_ROL
XFRONT Front media sensor XREAR
1 1 key
2 2 key
3 3 key
4 4 key
(7) Cover the front media sensor with a piece of paper.
The status of XFRONT changes from "L" to "H".
(8) Cover the rear media sensor with a piece of paper.
The status of XREAR changes from "L" to "H".
(9) Move the pen block to the far right. When the pen block reaches the home position flag, the status of
YHOME changes from "L" to "H".
(10) Lower the media set lever to raise the push rollers. The status of CAM changes from "L" to "H".
(11) Move the pen block to the left and right. When the pen block crosses the push roller, the status of P_
ROL changes from "L" to "H".
(12) Press each key on the control panel; the status will change from "L" to "H".
(13) When testing is completed, turn off the power.
FC9000-UM-251-9370
Short form Sensor or key
Push roller sensor CAM
Rear media sensor
Bar Barcode key
Lf Left arrow key Ri
Up Up arrow key Dn
Slo Slow key
Short form Sensor or key
Cam sensor
Pau Pause Menu key Ori
Right arrow key Cop
Down arrow key Esc
Cod Condition key Ent
34
9 TROUBLESHOOTING
Short form Sensor or key
Origin key
Copy key
ESC/Cross Cut key
Enter key