Table of Contents
Advertisement
How to reinstall the drive roller shaft assembly
(1) Reattach in the reverse order in which it was detached.
(2) When the drive roller shaft assembly is installing, confirm the position of bush as shown in the picture
below.
FC9000-140
FC9000-160
Drive roller shaft
assembly
Bush
(3) When the X drive pulley is installing to the drive roller shaft assembly, tighten the four M3L4 set screws
while pushing the drive pulley and the drive roller shaft assembly to the following direction.
(4) Spread a suitable quantity of Loctite 222 on the four M3L4WP set screws holding the X-drive pulley.
(5) Perform the X-drive belt tension adjustment (Refer to subsection 7.3.2.).
(6) Reattach the other parts in the reverse order in which they were detached.
FC9000-UM-251-9370
FC9000-75
FC9000-100
Bearing
Grid roller
Drive roller shaft assembly
7
DISASSEMBLY AND REASSEMBLY
Bearing
X drive pulley
7-35
Bush
Advertisement
Table of Contents
