Subnetwork Module Compatibility And Supported Quantity Charts - Distech Controls ECL/ECB-PTU Series User Manual

Subnetwork Module Compatibility and Supported Quantity
Charts
Not all subnetwork modules work with all controller models: The subnetwork module compati-
bility for an individual controller is shown in the table below along with the maximum supported
quantity of room devices and extension modules. The Subnet ID address of all subnet devices
must be set to be within the shown addressing range.
Adding devices to the subnetwork decreases system responsiveness which may
cause delays executing commands needing a fast response such as lighting and
shades/sunblind commands.
Table 16: Subnetwork Module Compatibility and Maximum Supported Quantity Chart
Controller
Subnetwork Data Bus Device
Model
ECL-VAV Allure EC-Smart-Vue series
ECB-VAV
Allure EC-Smart-Comfort series
Allure EC-Smart-Air sensor series
EC-Multi-Sensor series
ECx-Light-4 / ECx-Light-4D / ECx-
Light-4DALI
ECx-Blind-4 / ECx-Blind-4LV
ECx-4XX I/O Extension Modules
ECx-Display
ECL-VAVS Allure EC-Smart-Vue series
ECL-VAV-N
Allure EC-Smart-Comfort series
ECB-VAVS
ECB-VAV-N
Allure EC-Smart-Air series
EC-Multi-Sensor series
ECx-Light-4 / ECx-Light-4D / ECx-
Light-4DALI
ECx-Blind-4 / ECx-Blind-4LV
ECx-4XX I/O Extension Modules
ECx-Display
Network Guide
Subnetwork Installation Guidelines
Permitted Subnet
Maximum
ID Addressing
Quantity Allowed
1
Range
1 to 4
See below
1 to 4
1 to 4
1 to 4
- Not Supported
- Not Supported
1 to 4
4
1 to 4
- Not Supported
- Not Supported
- Not Supported
- Not Supported
- Not Supported
2 4
,
3
71