Lan Through An Allure Ec-Smart-Vue Sensor For A Lonworks Network - Distech Controls ECL/ECB-PTU Series User Manual

LAN through an Allure EC-Smart-Vue Sensor for a L
Network
To provide LAN access for a L
troller and Allure EC-Smart-Vue sensor must be enabled.
All L W controllers have Net to Subnet Port Settings jumpers which when enabled will
ON ORKS
bring down the L
see Figure 66 and
Recommendation: Only a limited number of controllers on a L
segment should have their Net to Subnet Port Settings jumpers enabled. Enabling
too many Allure EC-Smart-Vue sensors with network access may cause network
communication issues. If there are any network communication problems, refer to
the L
ON
The image below shows a typical L
trollers enabled for LAN access at the Allure EC-Smart-Vue sensor.
Figure 65: L W Network Data Bus Topology
ON ORKS
For maximum cable lengths and cable specifications for a L
ogy, refer to Network Cables
The length of the Allure EC-Smart-Vue sensor subnetwork data bus must also comply with the
restrictions shown in
Enabling the Net to Subnet Port Jumper
To connect the main L
two Net to Subnet Port Settings jumpers inside the ECL series controller to Enable. The fac-
tory-set default is disabled. Refer to the controller's Hardware Installation Guide for how to
identify and set a controller's Net to Subnet Port jumpers.
104
W
ON ORKS
W network to the Allure EC-Smart-Vue sensor (for jumper locations
ON ORKS
Figure 67).
W Troubleshooting section on page 60.
ORKS
W
ON ORKS
on page 55.
Subnetwork Data Bus Length
W network to the Cat 5e Cable subnetwork data bus, set the
ON ORKS
network, jumpers, or DIP switches on both the con-
network data bus topology with only a few con-
W
ON ORKS
on page 75.
W
ON ORKS
W network
ON ORKS
network data bus topol-
Network Guide