Huawei UPS5000-S-600 kVA User Manual page 57

UPS5000-S-600 kVA
User Manual (Singapore, Three-phase, Three-wire)
Figure 3-5 Expansion bolt composition
(1) M12 bolt
Knock the expansion bolt into the hole until the expansion sleeve completely fits
into the hole. The expansion sleeve must be completely buried under the ground
to facilitate subsequent installation.
Figure 3-6 Installing an expansion bolt (unit: mm)
1.
2.
3.
4.
Issue 01 (2021-04-14)
(2) Spring washer
NO TICE
Drill holes in the ground by using a hammer drill. The hole depth is 52 mm to
60 mm.
Partially tighten the expansion bolt and vertically insert it into the hole. Knock
the expansion bolt using a rubber mallet until the expansion sleeve is fully
inserted into the hole.
Partially tighten the expansion bolt.
Remove the bolt, spring washer, and flat washer.
Copyright © Huawei Technologies Co., Ltd.
(3) Flat washer
3 Installation
(4) Expansion sleeve
49