Particle Measuring Systems LASAIR II 310 Operator's Manual page 92

LASAIR II LASAIR II
communication communication
modes modes
COMM Setup Screens COMM Setup Screens
Serial screen Serial screen
Network screen Network screen
(Ethernet) (Ethernet)
Figure 7-1: Setup paths for communications modes Figure 7-1: Setup paths for communications modes
Ethernet Communications Setup Screen Ethernet Communications Setup Screen
Figure 7-2 is the Ethernet communications setup screen where all network Figure 7-2 is the Ethernet communications setup screen where all network
addressing parameters are set, and various network communication protocols addressing parameters are set, and various network communication protocols
are enabled or disabled. When a network address is changed, the LASAIR II are enabled or disabled. When a network address is changed, the LASAIR II
must be rebooted. A pop-up message must be rebooted. A pop-up message informs you of this when you try to
the screen. The various setup parameters are discussed below. the screen. The various setup parameters are discussed below.
LASAIR II Operator's Manual LASAIR II Operator's Manual
Configuring LASAIR II Communications Configuring LASAIR II Communications
❏ ❏
LASAIR II LASAIR II
(Select for normal RS-232 (Select for normal RS-232
communications) communications)
❏ ❏
PMS Multi-Drop PMS Multi-Drop
(Select for MiniLaz emulation (Select for MiniLaz emulation
with Facility Net) with Facility Net)
❏ ❏
Enable Web Server Enable Web Server
(Select for web browser interface) (Select for web browser interface)
❏ ❏
Enable TCP/IP Enable TCP/IP
(Select for PMS TCP/IP protocol (Select for PMS TCP/IP protocol
with Facility Net and Remote Mode) with Facility Net and Remote Mode)
❏ ❏
Enable TCP/IP Remote Mode Enable TCP/IP Remote Mode
(Select when operating in the (Select when operating in the
Remote Mode) Remote Mode)
informs you of this when you try to exit exit
Page Page
7-3 7-3