Particle Measuring Systems LASAIR II 310 Operator's Manual page 159

Appendix B: Connecting to a Computer or Network Appendix B: Connecting to a Computer or Network
Page B-2 Page B-2
Y Y our IS/computer support personnel our IS/computer support personnel will be able to
cable or fabricating a custom-length cable. cable or fabricating a custom-length cable.
NOTE: NOTE: Both types of cable are available from Particle Measuring Systems. Both types of cable are available from Particle Measuring Systems.
The Ethernet cables and their part numbers are listed below: The Ethernet cables and their part numbers are listed below:
Crossover Cable for use when connecting directly to a PC for use when connecting directly to a PC
Crossover Cable
without going through an Ethernet network without going through an Ethernet network
Straight-through (Ethernet) Cable for use when Straight-through (Ethernet) Cable
connecting to a PC by means of an Ethernet network connecting to a PC by means of an Ethernet network
Setting Up LASAIR II for Direct Web Browser Interface Setting Up LASAIR II for Direct Web Browser Interface
Direct web browser interface means that the LASAIR II is connected directly to Direct web browser interface means that the LASAIR II is conn
a PC without passing through an Ethernet network. a PC without passing through an Ethernet network.
Before proceeding, you must inform your Network Administrator that you Before proceeding, you must inform your Network Administrator that you
will be connecting to the network. The administrator will assign TCP/IP will be connecting to the network. The administrator will assign TCP/IP
addresses and may assist you in the configuration. addresses and may assist you in the configuration.
The minimum setup is assigning network addresses to both the LASAIR II and The minimum setup is assigning network addresses to both the LASAIR II and
the PC to which it will be connected. It may also be nec the PC to which it will be co
types of addresses, such as gateway and multicast. After changing TCP/IP types of addresses, such as gateway and multicast. After changing TCP/IP
addresses and exiting the Comm Setup Screen, you will prompted to reboot the addresses and exiting the Comm Setup Screen, you will prompted to reboot the
LASAIR II. LASAIR II.
Connecting the crossover cable: Connecting the crossover cable:
1 1 Insert one end of a crossover cable into the port labeled NET on the back of your Insert one end of a crossover cable into the port labeled NET on the back of your
LASAIR II. LASAIR II.
2 2 Connect the other end of the Connect the other end of the cable into the Ethernet port of
3 3 V V erify connection by means of erify connection by means of the connectivity LEDs at the LASAIR
connection and the computer's Ethernet connection. connection and the computer's Ethernet connection.
Setting LASAIR II's TCP/IP addresses for direct web browser interface: Setting LASAIR II's TCP/IP addresses for direct web browser interface:
1 1 Start LASAIR II (if necessary). Start LASAIR II (if necessary).
LASAIR II II Operator's LASAIR
will be able to assist you in procuring
C C a a b b l l e e
for use when
CAUTION CAUTION
nnected. It may also be necessary to specify other
cable into the Ethernet port of your computer.
the connectivity LEDs at the LASAIR II "NET"
Operator's Manual Manual
assist you in procuring a a
P P a a r r t t N N o o . .
AE1938 AE1938
CD22 CD22
ected directly to
essary to specify other
your computer.
II "NET"