Particle Measuring Systems LASAIR II 310 Operator's Manual page 126

When Using Auto-selection of User-created Location Names When Using Auto-selection of User-created Location Names
When the sample is complete, the following When the sample is complete, the
dialog box will display: dialog box will display:
To continue sampling: To continue sampling:
Move the LASAIR II to the next location. Move the LASAIR II to the next
1 1
Acknowledge the dialog box by pressing Acknowledge the dialog box by pressing
2 2
the the Enter Enter button. button.
On the Main Display On the Main Display, observe that LASAIR II has changed the
NOTE: NOTE:
location name to the next name in sequence. Example: from "Room 1 Col B12" location name to the next name
to "Room 1 Col B15." to "Room 1 Col B15."
3 3 Start the next sample by pressing the Start Start the next sample by pressing the
4 4 Repeat steps 1–3 until the LASAIR II notifies you that all samples are complete. Repeat steps 1–3 until the
When Not Using the Auto-increment Mode When Not Using the Auto-increment Mode
If you have not enabled auto-increment, the If you have not enabled auto-increment, the
following dialog box will be displayed following dialog box will be displayed
when sampling is completed at a loca when sampling is completed at a location:
To select the next location name and To select the next location name and
continue sampling: continue sampling:
1 1 Press the Enter Press the Enter button to close the button to close the Statistics
Update Update dialog box. dialog box.
2 2 Open the Sampling Setup Open the Sampling Setup screen.
3 3 Press the Press the Enter Enter button to activate the edit mode. The location selection box button to activate the edit mode. The location selection box will
be active when the screen changes to the edit mode. be active when the screen changes to the edit mode.
Use the up and down Use the up and down arrow buttons to highlight the location name you
4 4
use for the next sample. use for the next sample.
Accept the location name and navigate to the Main Display Accept the location name and navigate to the
5 5
Move the LASAIR II to the location that matches the location name you have Move the LASAIR II to the location that matches the location name you have
6 6
selected. selected.
Y Y ou could have moved the LASAIR II to the ou could have moved the LASAIR II to the next location at any point
NOTE: NOTE:
before pressing the Start before pressing the Start button.
Ensure that the proper location appears on Ensure that the proper location appears on the display and then p
7 7
button to collect the next sample button to collect the next sample
LASAIR II Operator's Manual LASAIR II Operator's Manual
following
location.
, observe that LASAIR II has changed the
in sequence. Example: from "Room 1 Col B12"
Start button. button.
LASAIR II notifies you that all samples are complete.
tion:
Statistics
screen.
arrow buttons to highlight the location name you want to
Main Display. .
button.
the display and then press the
Statistics Mode Operation Statistics Mode Operation
will
want to
next location at any point
ress the Start Start
Page Page
8-15 8-15