Particle Measuring Systems LASAIR II 310 Operator's Manual page 212

Writing TouchRam Buttons Writing TouchRam Buttons
To read a TouchRam button: To read a TouchRam button:
1 1 Attach the TouchRam wand to the Attach the TouchRam wand to the RS-232 connector.
Position and hold the TouchRam wand over the button. The button should fit Position and hold the TouchRam wand over the button. The button should fit
2 2
inside the receptacle on the wand. inside the receptacle on the wand.
3 3 If the LASAIR II is running, it will stop sampling. A If the LASAIR II is running, it will stop sampling. A dialog box will appear on
the screen indicating the name of the new location to load. the screen indicating the name of the new location to load.
4 4 Accept or reject the location by Accept or reject the location by pressing the Enter softkey when the proper
choice is selected. choice is selected.
The button writing utility is found on the The button writing utility is
T T o write o write to a to a T T ouchRam button: ouchRam button:
Navigate to t Navigate to the he Comm Setup -Serial Comm Setup -Serial screen
1 1
and the Enter and the Enter key to key to enable TouchRAM Read/Wr
Attach the TouchRam wand to the Attach the TouchRam wand to the RS-232 connector.
2 2
3 3 Navigate to the Navigate to the Location Setup Screen Location Setup Screen. .
The Location Setup Screen will already be in Edit mode. Also note The Location Setup Screen will already be in Edit mode. Also note
NOTE: NOTE:
that a TouchRAM icon appears on the screen when that a TouchRAM icon appears on
function is enabled. function is enabled.
Select a location. Select a location.
4 4
Navigate to the TouchRAM icon and press the Enter softkey Navigate to the T ouchRAM icon and press the Enter softkey. The Program
5 5
T T ouchRAM dialog bo ouchRAM dialog box will appear, directing you to
Position and hold the TouchRAM wand over the button. The b Position and hold the TouchRAM wand over the button. The button should fit
6 6
inside the receptacle on the wand. inside the receptacle on the wand.
7 7 If the LASAIR II is running, it will stop sampling. A data dialog box will appear If the LASAIR II is running, it will stop sampling. A data dialog box will appear
on the screen indicating the name of the location to write to the on the screen indicating the name
8 8 Accept or reject the write function by highlighting your choice and pressing the Accept or reject the write function by highlighting your choice and pressing the
Enter softkey Enter softkey. If you are writing to a . If you are writing to a button, a dialog box will appe
if the write was successful or unsuccessful. if the write was successful or unsuccessful.
LASAIR II Operator's Manual LASAIR II Operator's Manual
RS-232 connector.
pressing the Enter softkey when the proper
found on the LASAIR II's LASAIR II's Location Setup Screen
screen and use the appropriate and use the appropriate Arrow
enable TouchRAM Read/Write.
RS-232 connector.
the screen when T T ouchRAM Read/Write
x will appear, directing you to write the first button.
of the location to write to the button.
button, a dialog box will appear indicating
Writing TouchRam Buttons Writing TouchRam Buttons
dialog box will appear on
Location Setup Screen. .
Arrow keys keys
ite.
ouchRAM Read/Write
. The Program
write the first button.
utton should fit
button.
ar indicating
Page Page
M-3 M-3